Assembly, Installing the gear shift lever, Final adjustments rear tire pressure – Craftsman 247.887330 User Manual
Page 9: Awarning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
J
2.
Pull chute back towards the engine. While holding the chute with
one hand, remove the chute holder using your other hand.
3.
Carefully lower the chute against the deck and discard the holder.
INSTALLING THE GEAR SHIFT LEVER
1. Remove the 5/16-18 screw and the lock nut that hold the shift
lever to the shift lever plate, Figure 4.
FINAL ADJUSTMENTS
Rear Tire Pressure
AWARNING
Never exceed the maximum inflation pressure shown on the sidewall
of tire.
The recommended operating rear tire pressure is approximately 20
psi for the rear tires. Check the tire pressure periodically and maintain
equal pressure in both rear tires at all times.
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer’s
recommended or maximum psi. Do not overinflate. Uneven tire pres
sure could cause the cutting deck to mow unevenly.
3.
Remove the remaining screw and nut from the lower shift lever
plate. Figure 4.
Position the upper shift lever into a vertical position aligning the
holes in the lever to the holes in the shift plate. Figure 5.
Secure the lever to the plate using the two screws and two nuts
removed earlier. Figure 5.