Maintenance, S ^ v, A.itsj ik – Craftsman 358.791031 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Tip of the Line

Does The Cutting

Line Crowded into

Work Area

■ s

^ V ‘

Right

Wrong

• The line will easily remove grass

and weeds from around walls,

fences, trees and flower beds, but it

also can cut the tender bark of trees
or shrubs and scar fences.

• For trimming or scalping, use less

than full throttle to increase line life

and decrease head wear, especially:
• During light duty cutting.
• Near objects around which the line

can wrap such as small posts,

trees or fence wire.

• For mowing or sweeping, use full

throttle for a good clean job.

TRIMMING - Hold the bottom of the
trimmer head about 3 inches {8 cm)

above the ground and at an angle. Al­
low only the tip of the line to make
contact with vegetation. Do not force

trimmer line into work area.

Trimming

3 inches (8 cm) i"
above ground |

^

SCALPING - The scalping technique
removes unwanted vegetation down

to the ground. Hold the bottom of the

trimmer head about 3 in. (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground

around trees, posts, monuments, etc.

This technique increases line wear.

Scalping^

A.itsJ iK

MOWING - Your trimmer is ideal for
mowing in places conventional lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the

ground. Avoid pressing the head into

the ground as this can scalp the

ground and damage the tool.

Mowing

SWEEPING - The fanning action of

the rotating line can be used to blow

away loose debris from an area. Keep

the line parallel to and above the area

surface and swing the tool from side

to side.

Sweeping

MAINTENANCE

MAINTENANCE SCHEDULE

A

WARNING:

Disconnect the spark plug before performing maintenance

except for carburetor adjustments.

CARE & MAINTENANCE TASK

WHEN TO PERFORM

Check for loose fasteners and parts

Before each use

Check for damaged or worn parts

Before each use

Inspect and clean unit and labels

After each use

Clean air filter

Every 5 hours of operation

Inspect muffler and spark arresting screen

Every 50 hours of operation

Replace spark plug

Yearly

15

Advertising