Ássembiy (continued), Checking table insert, C hecking table insert – Craftsman 113.299210 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Ássembiy (continued)
Checking Table Insert
The table insert must be flush with the surface of the saw
table to keep the workpiece from hanging up or binding
with the sawbiade as the workpiece is cut by the saw-
blade.
1 Lower sawbiade beneath the table insert and check to
be sure the screw fastening the insert in place is snug,
2 Use a straight edge to check near each ot the eight
leveling tab positions to determine if the insert is flush
with the surface of the saw table at ail eight leveling
tab positions
3, If insert is not fiush with table surface, loosen insert
fastening screw and pull insert forward to lift from saw
table.
4 Bend with pliers or tap with a hammer, as required, to
make the insert flush with the table top.
Leveling
18