Blade tilt, or squareness of blade to table, Adjustments (continued) – Craftsman 113.299210 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Blade Tilt, or Squareness of Blade to Table
W hen the bevel pointer is pointing directly to the "0" m ark
on the bevel scale, the saw biade should m ake a square
cut 90“ to the table
Adjustments (continued) —
WARNING: To avoid injury from accidental start,
turn switch “OFF*' and remove plug from power
source outlet.
___________
To check for squareness, 90° position.
1, R aise blade all the w ay up, raise blade guard,.
2 Tilt blade a few degrees to the left Now tilt biade back
to the right as far as it w iii go
3- Place the square against the biade. M ake sure square
is not touching the tip of one of the saw teeth
4. If blade is square to table; check pointer
A it pointer does not point to "O " m ark on the bevel
scale, bend pointer to read “0"
Pointer Adjusting
Screw
40