Craftsman 320.48291 - Manual (Page 5)

DESCRIPTION
NEWl Magstic Non-Marring Adhesive Strips, (see Fig. 2)
Magstic is an innovative technology that is washable and reusable.. To use,
remove the “RED” tab (Tool Side) and apply the Magstic adhesive strip to the
underside of the tool's base, Remove the "GREEN" tab (Wall Side) and press
the tool firmly against the surface in the desired location. After leveling, carefully
remove the tool and base from the surface . Replace the green plastic tab on the
wall side of the Magstic for storage. The Magstic adhesive strips should remain
on the base of the tool. Once
Magstic is removed from the
tools base, it will no longer be
usable,
To clean the wall side of the
Magstic adhesive, wipe a
damp cloth across each strip,.
Once the wail side adhesive
has become non-usable,
replace with fresh adhesive
strips.
*U.OTE WAÌ4.IHIÌ! WAtLSEPE a.'RttSBE \
■' lift, - ,1/1. ’ ,W. ,Ui\
WAO.SIOE yAМ.М.Si3e iSAU-SH
,1/1. ~ ,1/1. ,Ul. ■" ,Ui.
lAtLSOe WALLSPOE 1
— dt —— dll -,1T—Jit________r..... ,i/J
Fig, 2
Placing Magstic on the Base
of the Palm Grip Laser Level
(see Fig. 3)
For best adhesion, place the
tool side of the adhesive on
the bottom of the base of the
tool first. Then position the
tool on the smooth wall or
surface in the desired loca­
tion., The too! can then be
leveled on the base for the
desired angle.
A CAUTION Remove the
Magstic from the wall after
use. Place the “wall-side"
protective tab back on the
adhesive material to help
keep it clean. If the Magstic ^9 3
material is soiled during use,
it can be cleaned with a damp cloth, Magstic is not intended to be used
once It has been removed from the tool. Once removed from the tool, the
strips will not be usable. Replace with new Magstic strips.
<182S1 ManusLRevlsed_060907
Pages