Craftsman 320.28190 - Manual (Page 25)

5, When cut is completed, turn router motor “Off” arjd let cutting bit come to a
complete stop before removing it from the work piece.
6. Unplug router from power source, place router upside down on worktable,
and inspect finished cut in work piece. I ’
WARNING: Always securely clamp your work fiiece and keep a firm grip
on the router base with BOTH HANDS at all timesJ Failure to do so could
result in loss of control causing possible serious pjersonal injury.
A. WARNING: Removing cutting bit from work pièce while it is still rotat­
ing could damage work piece and result in loss of «control, causing serious
personal injury.
!
NOTE: Making test cuts in scrap material that is similar to your work piece is
essential. Learning how the router’s speed, depth-of-cut and cutting bit will
react in the work piece will help you produce qualijty cuts.
INTERNAL ROUTING (Figs. 13,13a, 13b)
1. With depth-of-cut set, tilt
router and place on work
piece with leading edge of
sub-base contacting work
piece first (Fig. 13).
2. Turn router motor “On” and
let motor buiid up to its full
speed, being careful not to
let cutting bit contact work
piece..
3. To begin your cut, gradually
feed the cutting bit into the
work piece until the sub­
base is level with the work
piece (see Fig 13a, 13b).
4. When cut is completed, turn motor “Off” and let ciitting bit come to a com­
plete stop before removing it from the work piece, j
5. Unplug router from power source, place router upside down on worktable,
and inspect finished cut in work piece. !
i
WARNING: Removing cutting bit from work plelce while it is still rotat­
ing could damage work piece and result in loss of control, causing serious
personal injury.
I
2S1S0 ManualRevisetJ 07-0409 Page 25