Craftsman 706.596690 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ACTUATOR ROD BRACKET
INSTALLATION AND REMOVAL
Removal
• Disconnect power from unit.
• For roll-aways, remove work surface.
(See drawer and work surface
installation and removal.
• Remove enough drawers to reach the
top back inside of the unit. (See
Drawer and Work surface installation
and removal.)
• Remove top from unit. (See top
installation and removal for your unit.)
• Pull actuator rod bracket forward. Lift
out to remove.
Installation
• Insert actuator rod bracket into hole in
back corner of unit. Ensure actuator
rod bracket snaps into place. Note:
The flexible tab should be in front.
• Reinstall top in unit.
• Insert back of actuator rod into
actuator rod holder in top back of unit.
• Push actuator rod toward back of unit
and line up with lock. Insert actuator
rod into back of lock.
• Test lock operation.
• Reinstall drawers.
• Reconnect power to the unit.
LOCK BAR INSTALLATION AND
REMOVAL
Removal
• Disconnect power from the unit.
• For roll-aways, remove work surface.
(See drawer and work surface
installation and removal.
• Remove all drawers.
• Remove actuator rod and actuator
channel. (See actuator rod and
actuator channel installation and
removal.)
• Remove top from unit.
• See top removal for your unit.
• Lift lock bar out through hole in top of
unit.
Removal
• Insert lock bar through hole in top of
unit.
• Slide lock bar down through lock bar
guide.
• Reinstall top on unit.
• Reinstall actuator channel and
actuator rod.
• Test lock operation.
• Reinstall drawers.
• Reconnect power to the unit.