Slide replacement – Craftsman 706.596690 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SLIDE REPLACEMENT
Tools Required:
Drill
5/32" Drill bit
Rivet gun
Removal
• Remove drawer or work surface from
unit. (See drawer and work surface
installation and removal.)
• Carefully drill out rivet holding slide
drawer member to drawer or work
surface.
• Rotate front of slide drawer member
down and out.
• Pull slide forward to remove.
• Carefully drill out rivet holding slide
unit member in place.
• Pull slide unit member forward to
remove.
Installation
• Separate slide drawer member from
unit member. (See drawer and work
surface installation and removal.)
• Install new slide unit member. (Install
back hanger first.)
• Rivet unit member in place as shown.
• Install drawer member. (Install back
hanger first.)
• Install rivet to hold slide drawer
member in place.
• Reinstall drawer or work surface into
unit. (See drawer and work surface
installation and removal.)