Craftsman 706.596690 - Manual (Page 30)

CRRFTSMRN
LOCK REPLACEMENT
Removal
• Disconnect power from unit.
• For roll-aways, remove work surface.
(See drawer and work surface
installation and removal
• Remove enough drawers to reach the
lock retaining clip behind the lock.
• Remove lock retaining clip. Pull lock
out to remove.
Installation
• Position lock in unit. Install retaining
clip to hold lock in place.
• Make sure the back of the actuator
rod is inserted into the actuator rod
holder in the back of the unit.
• Push actuator rod toward back of unit
and line up with lock. Insert the
actuator rod into the back of the lock.
• Test lock operation.
• Reinstall drawers.
Lock
Rekeying MASTERLOCK ONE-
KEY™ lock
The MASTERLOCK® ONE-KEY™
learning lock system allows the
chest and cabinet to be keyed alike.
The lock can also be keyed to most
house keys.
• Insert current key and turn lock to
the right until access notch
appears at top of lock,
• Depress and hold catch through
access notch using re-keying tool
provided.
• Remove key.
• Insert new key.
• Release catch
• Turn lock to center position,
• Remove key
Note: Catch must be depressed to
insert or remove key in right hand
position. Catch may be released
between keys.
Access
Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA
FI 623