Nikon N80 - Manual (Page 82)

I
Using the Built-In Speedlight
I Operation described in this section applies when the built-in Speedlight
and D- or G-type AF Nikkor are attached.
2
Set the metering system.
• Set the metering system to Matrix or Center-Weighted Metering.
Release the built-in Speedlight by pressing the flash
lock-release button, and set the flash sync mode by
rotating the Main-Command Dial while pressing the
D button.
3
• Speedlight starts to charge when it is released and i appears in the
viewfinder when Speedlight is fully charged.
• Press the Speedlight down gently until it clicks into place to retract it. (To
conserve power, keep the Speedlight retracted when it is not in use.)
Set exposure mode and confirm shutter speed and
aperture.
• Note that Automatic Balanced Fill-Flash with TTL Multi Sensor is executed
with the exposure mode set to Auto-Multi Program, Shutter-Priority Auto or
Aperture-Priority Auto, and Standard TTL with the Manual.
• Available shutter speed and aperture in each exposure mode
Exposure mode Available shutter speed Available aperture Page
Auto-Multi Program
Automatically set
(1/125-1/60 sec.'i) Automatically set
50
Shutter-Priority Auto 1/125-30 sec.*2 52
Aperture-Priority Auto
Automatically set
(1/125-1/60 sec.'i) Desired setting's
54
Manual 1/125-30 sec.*2, buLb 56
82
*1 Shutter speed is prolonged up to 30 sec. with Slow Sync, Rear-Curtain Sync and Red-Eye
Reduction with Slow Sync.
*2 Shutter speed shifts automatically to 1/125 sec. when the shutter speed is set to faster than
1/125 sec. and the flash is fired (or attached optional Speedlight is turned on). In this case,
125 appears in the viewfinder and the selected shutter speed display blinks in the LCD panel.
*3 Flash shooting distance range depends on the ISO film speed of the film in use and
aperture selected. In Aperture-Priority Auto or Manual exposure mode, set the aperture
according to the flash shooting distance range table on page 83.