Canon E 200 User Manual
Page 73
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Problem
CauM
Remedy
Camera does tx3t turn on.
Battery pack charge is low.
Replace with fully charged
battery pack.
Camera turns off during
operation (using battery pack).
Battery pack charge is low.
Replace with fully charged
battery pack.
Record pause mode has lasted
for more than 7 minutes.
Turn camera on again.
Video cassette compartment
does not open.
Battery pack charge is low.
Replace with fully charged
battery pack.
Camera does not function
when an operation button is
pressed.
Camera is turned off.
Turn camera on.
Video cassette is not loaded.
Load a video cassette.
Battery pack is not properly
attached to the camera.
Attach battery pack securely to
the camera (see p. 14).
Start/stop button is pressed, but
recording does not start
Camera is turned off.
Turn camera on.
Video cassette is not loaded.
Load a video cassette.
Tape has ended (T. END"
appears in viewfinder).
Rewind tape or use another
video cassette.
Erasure prevention switch on the
video cassette is set to prevent
recording.
Use another video cassette or
set switch to enable recording
(see p. 28).
Camera is in playback mode.
Press • (REC) button.
No picture appears in
viewfinder.
Lens cap is attached.
Remove lens cap.
Cannot adjust focus.
Zooming lever is in macro range.
Move zooming lever into normal
focusing range.
Viewfinder diopter is not property
adjusted.
Turn diopter adjustment ring
until viev^nder display
becomes dear (see p. 25).
Autofocus window is obscured.
Remove obstade from
autofocus window.
Playback doesn't start when
PLAY button is pressed.
Camera is in record mode.
Press ■ (STOP) button.
Camera is turned off.
Turn camera on and press ■
(STOP) button.
Video cassette is rx3t loaded.
Load a video cassette.
Tape has ended (T. END”
appears in viewfinder).
Rewind tape or use another
video cassette.
>
о
о
о
Z
>
о
г
5
о
73