Canon E 333 D - Manual (Page 74)

Problem Cause Remedy
For a TV without audio/video
input terminals: the video
channel has not been set
properly on both the TV and the
RF unit. Set the TV and the RF unit to
the appropriate video channel.
The tape is moving, but no
picture appears on the TV
monitor.
For a TV with audio/video input
terminals: TheTV/VIDEO
selector on the TV has not been
set to VIDEO.
Set the TV/VIDEO selector to
VIDEO.
The video heads are dirty. Clean the video heads using
the optional CK-E1 Cleaning
Kit.
The battery pack is exhausted. Charge the battery pack.
The camera is not in record
pause or record mode. Place the camera in record
pause or record mode.
The pop-up light will not turn
The camera is not turned on. Turn the camera on.
on.
The bulb has burned out. Replace the bulb.
A cassette has not been loaded. Insert a cassette and place the
camera in record pause or
record mode.
Smear BtiTO
A luminous bar appears vertically on the screen where an
excessively bright scene was recorded.
Smear is caused when:
• Spotlights are directly recorded, on a stage for example.
• Burning candles or other burning objects are recorded
directly.
• Objects reflecting light, such as car bodies and traffic signs,
are recorded directly.
Poor playback picture on TV monitor lltiMtl
Loss in video playback picture quality such as blurring,
distortion or noise usually means that the video heads have
become dirty. Use the optional Canon 8mm Video Head
Cleaning Cassette CC-8 included in the Canon 8mm Video
Cleaning Kit CK-E1 to clean the video heads. See the CC-8
instruction manual for details.
80
Note:
•
This equipment contains a microprocessor. If external noise or interference occurs, random letters may
appear in the viewfinder or normal operation may be interrupted. In this case, remove and then replace
the power source (and if necessary, the lithium battery).