Using red-eye reduction (with the built-in flash), I "r, Using red-eye reduction – Canon Rebel T2 300X User Manual
Page 24: With the built-in flash)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
<§> Using Red-eye Reduction
(with the built-in flash)
When flash is used in a loW'light environment, the subject's eyes may come out
red in the photograph To reduce this "Red eye" the r^i^ye reduction lamp
shines a Hght into the subject's eyes before the ftash is fired Red-eye reduction
works in an shooting modes except < St > <%y> <S>._____________________
Move the <^> arrow to the <^> icon
on the LCD panel.
• Look at the LCD panel and press the
<FUNC.> button to move the arrow. {(2»6)
Turn the <iSs> dial to set on the
LCD panel.
• Press the shutter button halfway to return
to normal camera operation.
• To cancel red-eye reduction, set “0” on
the LCD panel
S
' When you press the shutter button
the red«ye reduction larrv-on irtoical№)Mll
appear In viewfinder and on the LCD p^.
' Red-eye reduction wilt not work unless the
sii^ loota at the red-eye reduction iairp.
Tell the subject to kxik A the tamp,
' For maximurn effectiveness, press the
shuter button fully after the red-eye redLotlon
lamp turns off (after
1
.5 sea).
' You can takes picture even wfie the red-eye reduction larrpie lit.
' The effecUvoness of red-eye reduction varies depending on the subject
' To lurther Increase the effac№«nesa of red-eye rsckJdiort. go to a brt£^iter
environment or move doser to the subject
i "r
Red-eye reduction
lamp-on indtoator
22