Canon DR-5060F - Manual (Page 63)

61
Setting Detailed Scan Conditions
3
Setting Scan Conditions
The following information is saved to log files.
q Scanned date (MM/DD/YYYY format)
The date when the image was scanned is saved in the format MM/DD/
YYYY. If you want to change this format, contact a Canon service
department.
w Time (HH:MM:SS format)
e Directory/file name
When originals are scanned by [Scan Page] (See “Scan Page” P. 25), this
item is left blank. However, when scanned images are saved by [Save Page
As] (See “Saving Scanned Images to File (Scan Page)” P. 36), the
directory/file name is saved to the log file.
r Film address
The file address and page address are saved. When originals are scanned
in the Scanner Only mode, the film address becomes None.
t Camera ID
The ID number (#1 to #15) currently set to the camera unit in use is saved.
y Print/addon text
The text that was printed/added on and the barcode information is
enclosed by “””. When this item is opened in a spreadsheet application that
supports CSV format, it is displayed in a single cell with the text enclosed
by “. (Information is not delimited in individual cells even if the text contains
a comma.) Note, however, that when the text is an arrow, the special
characters that you entered to the text (See “Arrow” P. 71) are saved to the
log file.
u Barcode information
Information for up to four barcodes is saved. When barcodes are scanned
in the Duplex mode, the barcode information is saved to the log of the side
on which the barcode was searched.
Dropout
Set the dropout function. This function is for disabling scanning of the color red in
originals.
To use this function, select “Red Drop” from the pulldown menu.
[Inhibit Section]
Set the section in which dropout is inhibited when it is enabled.
Specify the start position and the end position, with each of these positions as
a distance in mm from the top edge of the paper.
MEMO
Only the color red can be dropped out on DR-5060F.