Appendix a: restore factory default settings – AVer SF1311H-CP User Manual
Page 57
53
Appendix A: Restore Factory Default Settings
There is a button hidden in the pinhole near to the RJ-45 connector. This button is used to restore the all
factory default settings. Sometimes restarting the device will make the system back to a normal state. However,
if the system still got problems after restart, user can restore the factory default settings and install it again.
Restore the device:
1. Insert the paper clip or other suitable tool to press and hold the button down continuously.
2.
Hold it least 3 seconds and release the tool. Then the device has been restored to default settings
and reboot again.
[Note] Restoring the factory default setting will lose the all previous settings included IP address forever. User
needs to run the IPWizard II program to search the device and configure it to let the device work
properly again.
Factory Default Reset