AVer SF1311H-DV - Manual (Page 10)

6
Hardware Installation
1. Use the L-wrench to loosen the tamper-resistant housing cover (with screws still attached
on the cover). The unit has a factory installed side conduit entry and one may adjust the
cables to back conduit entry according to installation requirement.
2. Set the mounting base onto the wall or ceiling and center it over the mounting hole, using four
retaining screws to secure the main body.
3. Set the proper image by moving the camera body (some model may limit the PCB board to
180° rotational adjustment) and set the focus by turning the lens to the left or right direction.
4. When the camera focus adjustment has been completed, use the L-wrench to fasten the
tamper-resistant housing to the main body.
5. Vari-Focal Dome Operation Guide: Once the picture appears on the monitor, open the cover
and adjust the lens wrench to “Near←→Far”, get the view zoom that you desire, and then
adjust the focus wrench of the lens to obtain the best picture. After adjustment, tighten both
wrenches.
6. CAT 5 cable must connect to the hub or switch, and the DC-Jack must connect to the power
source. Connect the other cables and connectors if necessary.
1. Near
2. Far
3. Wide
4. Focal Adjustment
5. Tele
6. Zoom Adjustment