AVer SF1311H-DV - Manual (Page 8)

4
Connections
 RS485 & DI/DO
Name Cable Color Function
12V Output Brown/White DC 12V (50mA maximum)
GND Blue/White GND
D+ Purple/White RS485 TX +
D- Gray RS485 TX -
DI Green/White Digital signal input(sensor)
DO Orange/White Digital signal output (alarm)
 MIC in (audio in): Connect an external microphone to the IP camera.
 Line out (audio out): Connect a speaker to the IP camera. This function is for voice alerting
and two-way audio.
 12V DC Jack: Connect to the power adaptor that included in the package (12VDC) .
 RJ45 LAN Socket: Connect to PC or Hub/Switch.
For connections to 10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This Ethernet port
built N-Way protocol can detect or negotiate the transmission speed of the network automatically.
Please use CAT 5 cable to connect the IP Camera to a 100Mbps Fast Ethernet network switch
or hub.
In the RJ-45 LAN socket, there are two LEDs embedded:
LAN LED (green color): This LED will be flashing while network accessing via Ethernet.
Power or Wireless LED (orange color): This LED is used to indicate whether DC power is ON or
OFF. In addition, this LED will be flashing while the wireless accessing the camera.
 Factory Default Reset: This button is used to restore all factory default settings.
Restore the device:
1. Press the button down continuously.
2. Hold the button at least 5s seconds and release it. Then the device has been
RJ45
RS485 & DI/DO
12V DC in
MIC in
Line out
Factory Default
Reset