AVer SF1311H-DV - Manual (Page 54)

50
Appendix B: Troubleshooting & FAQ
Question Answer or Resolution
Features
The video and audio codec is
adopted in the device. The device utilizes H.264, MPEG4 and JPEG triple compression to
providing high quality images. Where H.264 and MPEG4 are standards
for video compression and JPEG is a standard for image compression.
The audio codec is defined as AMR for 3GPP and G.711/G.726 for
RTSP streaming.
The maximum number of
users accesses the device
simultaneously. The maximum number of users is limited to 20. However, it also
depends on the total bandwidth accessed to this device from clients.
The maximum data throughput of the device is around 20~25Mbps for
UDP mode and 10Mbps for HTTP mode. Therefore, the actual number
of connected clients is varying by streaming mode, settings of
resolution, codec type, frame rate and bandwidth. Obviously, the
performance of the each connected client will slow down when many
users are logged on.
The device can be used
outdoors or not. The device is not weatherproof. It needs to be equipped with a
weatherproof case for outdoors using. However, equipped with a
weatherproof case might disable the audio function of the device.
Install this device
Status LED does not light up.  Check and confirm that the DC power adaptor, included in
packaged, is used. Secure the power connector and re-power it on
again.
 If the problem is not solved, the device might be faulty. Contact
your dealer for further help.
The network cabling is
required for the device. The device uses Category 5 UTP cable allowing 10 and/or 100 Base-T
networking.
The device will be installed
and work if a firewall exists
on the network. If a firewall exists on the network, port 80 is open for ordinary data
communication. The HTTP port and RTSP port need to be opened on
the firewall or NAT router.
The username and password
for the first time or after
factory default reset
Username is admin and password is admin
Note that it‟s all case sensitivity.
Forgot the username and
password Follow the steps below.
1. Restore the factory default setting by press pressing and holding
down more than 5 seconds on the device.
2. Reconfigure the device.
Forgot the IP address of the
device Check IP address of device by using the IPWizard II program or by
UPnP discovery.
IPWizard II program cannot
find the device  Re-power the device if cannot find the unit within 1 minutes.
 Do not connect device over a router. IPWizard II program cannot
detect device over a router.
 If IP address is not assigned to the PC which running IPWizard II
program, then IPWizard II program cannot find device. Make sure
that IP address is assigned to the PC properly.
 Antivirus software on the PC might interfere with the setup
program. Disable the firewall of the antivirus software during
setting up this device.
 Check the firewall setting of your PC or Notebook.
Internet Explorer does not
seem to work well with the
device Make sure that your Internet Explorer is version 6.0 or later. If you are
experiencing problems, try upgrading to the latest version of
Microsoft‟s Internet Explorer from the Microsoft webpage.