BoonDocker ARCTIC CAT: 2012-14 ProClimb M8 Intercooled - Manual (Page 2)

1. Remove the side panels. Remove the six torx bolts
holding the hood. Two bolts are located underneath
the nose cone, two bolts in the shock tower and two
bolts holding the hood to the tank cowl. Un-hook the
instrument/headlight harness then remove the hood.
2. Remove the springs holding the expansion chamber to
the Y-pipe. Remove the spring holding the expansion
chamber to the chassis. Remove the springs holding the
silencer to the Y-pipe and chassis. Remove the tempera-
ture sensor from the expansion chamber. Remove the ex-
pansion chamber and silencer from the machine.
3. Remove the three rubber bumpers from the silencer.
These bumpers will be re-used later in the turbo in-
stallation.
4. Remove the ECU heatshield by removing the two
screws holding it to the chassis.
5. Un-hook the two connectors from the ECU and re-
move the ECU and cowl as an assembly.
6. Using a 3/16” drill bit drill out the three rivets holding
the powervalve servo motor to the chassis.
BoonDocker tollfree: 877-522-7805 local: 208-542-4411 fax: 208-524-7381 www.boondockers.com 2