BoonDocker ARCTIC CAT: 2012-14 ProClimb M8 Intercooled - Manual (Page 8)

BoonDocker tollfree: 877-522-7805 local: 208-542-4411 fax: 208-524-7381 www.boondockers.com 8
37. Remove the upper tank shroud 38. On kits with a fuel booster board, plug the two pin
rubber molded connector into the accessory plug lo-
cated next to the chaincase. Plug the matching con-
nectors on the booster board inline with the fuel
pump connector.
39. Route the Control Box Injector and ADA harness along
the stock harness on the MAG side of the chassis, un-
derneath and behind the jackshaft, up the frame up-
right behind the clutch and out of the upper tank cowl.
Refer to the wiring diagram included in these instruc-
tions to see the connections between the BoonDocker
electronics.
40. Locate the stock wiring harness that runs down the
inside of the MAG side frame rail. Remove the zip-tie
and unplug the three pin molded connector. Plug the
supplied power adaptor inline with the connector.
Later in the installation the two molded connectors
will be used to power the oil pump and on intercooled
kits the fan intercooler fan.
41. If using a BoonDocker E-Key Timing Module plug it in-
line with the matching stock connectors. The “IN” con-
nectors will be towards the front of the machine and
“OUT” towards the rear. Wrap the velcro jacket around
the harness connections and secure the E-Key on the
outside of the jacket using zip-ties.
42. Grind the upwards edges on the powervalve servo
motor bracket flat. The bracket will be relocated to
the MAG side chassis diagonal, the removal of the
upward edges is to prevent rubbing on the throttle
cable.