BoonDocker POLARIS: 11-12 PRO 800 Turbo 3D Tuning - Manual (Page 2)

BoonDocker Performance – 2379 Heyrend Way, Idaho Falls, ID 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 1-20-11 Copyright © 2010 Boondocker Page 2 of 14
II. Installation of Fuel Injection Harness
There are two 10-pin connectors at the end of the black cable on the Control Box. One is for the EFI Harness and the other
is for the Transducer Harness. These two connectors are keyed (male/female) so only the correct connectors will mate.
However, you must be careful to not cross the 6-pin connectors for fuel injectors (EFI Harness) with the connectors for the
Electronic Boost Controller (EBC), which is available separately. The EFI Harness is shown below.
Install the EFI Harness as follows. Note: Use Dielectric Grease in all connectors to help prevent corrosion on the
terminals.
1. Locate the six-pin connector behind the center of the engine cylinders and just above the throttle bodies. This is the
sled’s EFI harness. Lift the latch to disconnect it.
2. Connect the Boondocker EFI harness between these two connectors.
3. Route the Boondocker EFI harness from this location upward where the white 10-pin connector will later connect to the
Fuel Control Box pigtail connector.
4. Route the cable with the remaining connector to the Auxiliary Injectors and plug it in.
5. Connect the ring terminal on the black wire to a solid chassis ground. It is very important to have good electrical
contact. It must be attached in such a way that it cannot come loose.
6. Double check the routing of all wires to be sure they are away from hot areas and moving parts. Use zip ties to secure it.