Cuddeback NOFLASH - Manual (Page 11)

TURNING CUDDEBACK ON AND OFF
To disarm Cuddeback and prevent it from taking
pictures, slide the On/off switch to the OFF posi-
tion. The date and time will be maintained.
To turn Cuddeback on, slide the On/off switch to
the ON position ( figure 29 ). If messages do not
appear on the LCD, replace the D Cell batteries.
When you slide the On/off switch to OFF, there
may be a delay before Cuddeback turns off.
Viewing the Battery Level
When you start Cuddeback, the display shows
the battery level of the 4 D Cell batteries. Battery
level reading is 100%, 75%, 50%, 25%, or 10%
( figure 30 ). When the batteries fail, the message
"Battery Failed" will be displayed.
STORING CUDDEBACK
If you intend to store your Cuddeback for more
than a month or two, we recommend that you
remove the batteries to eliminate any chance of
battery leakage.
Figure 29
20
TIP - Batteries fail sooner in cold temperature.
When temperatures are below 30 degree Fahrenheit,
you may want to replace the batteries when the
battery level is 25%.
Battery
100%
Figure 30
21
LEARN - You should now have a good
understanding of Cuddeback operation
and be able to use Cuddeback in the
field. The remainder of this manual
describes advanced features that you
do not need to learn to begin using
Cuddeback. We recommend learning
the Advanced Mode only if you wish.
CUDDEBACK ADVANCED MODE
Advanced Mode enables the following addi-
tional features you may find beneficial:
• Ability to turn the flash on or off
• Set the flash power
• Program Cuddeback to take videos
• Program the time of day Cuddeback will
trigger an image
• View a wealth of statistical data
• Enable event recording
• Enable password protection
• Write your name and phone number into
Cuddeback's memory
• Enable time lapse photography
• Enable Surveillance Mode (endless loop
recording of images)
To enable Advanced Mode
1) Remove the batteries from Cuddeback.
2) Install the batteries. Slide On/off switch ON
3) When the display prompts [E-Z Mode
Change?] immediately press
( figure 31 ).
4) The display will prompt [ADV Mode]
( figure 32 ).
Figure 31
ADV Mode
Figure 32
EZ Mode
Change?
NoFlash07OwnerManual 11/6/07 3:26 PM Page 11