Cuddeback NOFLASH - Manual (Page 6)

STEP 2 - TURNING CUDDEBACK ON
1) Slide the On/off Switch to the OFF position
( figure 4 ).
2) Remove the Compact Flash card if it is
installed ( figure 5 ).
3) Install 4 brand new alkaline D cell batteries.
( figure 6 ). We recommend Rayovac or
Duracell brand batteries only!
4) Install the Compact Flash card.
5) Slide switch to ON. Do not press any key
at this time.
6) In a few seconds the battery level will be
displayed ( figure 7 ). In a few seconds the
date & time will be displayed ( figure 8 ).
Figure 4
Figure 5
10
TIP - Always remove the Compact Flash
Card when removing or installing batteries.
This will make it easier to remove the bat-
tery plate and prevent damage to the card. Figure 7
Figure 8
4/05/06
11:13
AM
Battery
100%
TIP - Don't be afraid to press the keys to
learn Cuddeback operation. You can not
damage your Cuddeback by pressing keys.
If you need to start over slide the power
switch to OFF, and then back to ON to
restart Cuddeback.
11
How to install batteries into your Cuddeback
1.
Unscrew
battery
thumb
screw.
2.
Pull metal
plate and
thumb
screw up
and out.
4.
Replace metal plate.
Push down to secure
firmly behind center
and bottom lips.
1. Unscrew battery thumb screw.
2. Pull metal plate up and out.
3. Remove batteries.
4. Replace metal plate.
5. Screw in thumb screw.
To remove batteries
Figure 6
3.
Insert
batteries.
5.
Screw battery
thumb screw
back in.
➤ Center
Lip
Battery
orientation
➤
Bottom Lip
NoFlash07OwnerManual 11/6/07 3:26 PM Page 6