Cuddeback NOFLASH - Manual (Page 14)

26
LEARN - You have now successfully
entered the default Owner Password of
00000. You can cancel setting the
Owner Password at this time by press-
ing (M). If you want to continue and
set your Owner Password, continue as
described next.
c. Press to advance to the next digit.
00 will be displayed.
d. Press three more times. A 0 will be
added to the display each time is
pressed.
e. When five 0s are displayed, press .
5) The display will prompt [New OPW <0 >]
(
figure 38 ). (OPW is the abbreviation for
Owner Password).
Follow these steps to continue to program the
owner password.
Step 2 - Enter the 5 numbers you want for the
owner password
6) The display should be [New OPW <0 >]. If
not, repeat steps 1 through 5 above.
7) Enter the 5-digit number password you desire
using the method described in step 4 above.
8) After all 5 numbers are entered press .
The display will prompt [RepeatPW <0 >]
(
figure 39 ).
Step 3 - Repeat the 5 numbers for the owner
password
9) Enter the 5-digit number again, then press .
10) If both sequences of numbers are identical the
display will prompt [Saved!]. If the saved mes-
sage does not appear, the password was not
programmed and you will have to repeat the
entire process.
11) Press to continue to set the Lock Password.
LEARN - When setting a password,
(DOWN) changes the number and
(UP) advances to the next position.
New OPW
<0 >
Figure 38
Repeat PW
<0 >
Figure 39
TIP - You can cancel setting the
password at any point before
Saved! is displayed by pressing (S).
SETTING THE LOCK PASSWORD
The method to set the lock password is similar
to setting the owner password. To change the
lock password you must first enter the owner
password. The default owner password is
00000. If you changed the owner password,
you will need to enter that password instead.
Step 1 - Enter the owner password to enable
changing the lock password
1) If you have just programmed the Owner
Password, the Lock Password will be dis-
played. If not, follow steps 2 and 3.
2) Press numerous times until [Theft
Stop? C = Yes] appears on the LCD.
3) Press . The display will prompt [Owner
PW Change?].
4) Press again. The display will prompt [Lock
PW Change?] ( figure 40 ).
5) Press . The display will prompt [Owner
PW <0 >].
6) Enter the owner password using the method
previously described. After all 5 numbers are
entered, press . If you did not program the
owner password, you need to enter the default
owner password 00000.
TIP - For the best security you
should use different numbers for
the owner and lock passwords.
27
Lock PW
Change?
Figure 40
NoFlash07OwnerManual 11/6/07 3:26 PM Page 14