Cuddeback NOFLASH - Manual (Page 22)

Capture Mode. This selects what type of action
will trigger an image. The options are Motion,
Time Lapse, Both.
➢ Motion - Cuddeback will activate the camera
when it senses an animal/person with its
motion/heat sensor. This is the setting you
use to photograph animals that travel past
Cuddeback (
figure 70 ).
➢ Time Lapse - Cuddeback will activate the
camera on a time lapse interval. In this mode,
the motion/heat sensor is disabled. If an ani-
mal travels past Cuddeback, an image will
NOT be taken (
figure 71 ).
➢ Both - Cuddeback will activate the camera
when it senses an animal and on the pro-
grammed time lapse interval (
figure 72 ).
1) Press numerous times until [Camera
Setup? C = Yes] is displayed.
2) Press . [Capture Mode] will be displayed.
On the second line of the display the current
mode will displayed (Motion, TimeLpse, or Both).
3) Press or to change the setting.
If you enable time lapse photography, you will
then need to program the Time Lapse Interval
and Time Lapse Start Time.
(Note - the next two settings will only appear if
Capture Mode is Time Lapse or Both).
LEARN - Press (UP) 3 times to see all the available settings
described above.
42
Capture Mo
Both
Figure 72
Capture Mo
Motion
Figure 70
Capture Mo
TimeLpse
Figure 71
43
Time Lapse
12 Hours
Figure 73
PROGRAMMING THE TIME
LAPSE INTERVAL
The interval between images can be programmed
from 1 hour to 96 hours.
1) After you select a Capture Mode of Time Lapse
or Both, press . [Time Lapse Interval] will
be displayed.( figure 73 )
2) Press or to change the interval
between images.
3) When you have entered the correct time
interval, press to continue to the Time
Lapse Start Hour.
PROGRAMMING THE TIME LAPSE
START HOUR
You need to program the time of day you want
the time lapse image sequence to start. If you
don't care when the sequence starts, you can
program the Start Time to be Next Hour, which
will begin the sequence at the start of the
next hour.
1) After you program the Time Lapse Interval,
press . [Time Lapse Start Hour] will be
displayed.
2) Press or to change the start hour.
The range is any hour of the day and Next Hour.
To begin the time lapse operation, you must
enter Live Mode as described on page 14.
NoFlash07OwnerManual 11/6/07 3:26 PM Page 22