Dynojet 250i: Control Panel Interface Upgrade (S/N 202xxxx) - Manual (Page 11)

9
22. Connect the wires from the DIN power rail to the Control Panel Interface board.
23. Connect the brown wire from the bottom DIN terminal #1 to Tab 4 on the Control Panel Interface
board.
24. Connect the blue wire from the bottom DIN terminal #4 to Tab 3 on the Control Panel Interface board.
25. Connect the brown wire from the bottom DIN terminal #2 to Tab 2 on the Control Panel Interface
board.
26. Connect the blue wire from the bottom DIN terminal #5 to Tab 1 on the Control Panel Interface board.
Add cable ties as shown in the picture. Cut the cable ties flush.
Tab 4 Tab 3
Tab 2
Tab 1
#1 #5