Dynojet 250i: Control Panel Interface Upgrade (S/N 202xxxx) - Manual (Page 9)

7
14. Slide the Control Panel Interface board assembly into the rear of the Power Distribution assembly as
shown. Make sure to have the sheetmetal centered in the guides. Fasten the assembly in place with
two 8-32 x 3/8-inch screws in the back and two in the front.
15. Install the P/N 97422010 connector sticker to the front of the Power Distribution assembly.
8-32x3/8-inch
screws
8-32x3/8-inch
screws