Dynojet 250i: Control Panel Interface Upgrade (S/N 202xxxx) - Manual (Page 14)

12
33. Route the P/N 76950308 Pod to Carriage cable from P8 on the Control Panel Interface board to the
front cable hole on the dyno. The cable passes under the center partition in the carriage module and
in front of the vertical angle. Make sure that the cable strain relief end with the conduit nut is at the
end of the cable that will connect to the carriage. The strain relief for both the Power Carriage and the
Wheel Clamp must end up outside of the dyno.
34. If you already had the serial cable to the PC routed through the front panel put it in with one of the
new cables and put the snap bushing around the cable. Install the cable pass through cover with the
two holes as shown.
Strain
relief