Installation, Installing the front support – Dynojet Scooter Dyno SD-12 Installation Guide User Manual
Page 20
Advertising
Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 2
Installation
2-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
Use the following steps to install the scooter dyno.
You will need the following parts:
• Drum
• Front Support
• Ramp
• 197104130 Cable Tie, 4" (2)
• 22100011
Axle Shaft (2)
• 32800000
Retaining Ring, 1/2" (4)
• 36561045
Screw, 1/4-20 x 5/8", Pan-head, Torx (2)
• 71300003
Wheel Clamp
I
NSTALLING
THE
F
RONT
S
UPPORT
1
Place the front support on the drum.
Figure 2-2: Place Front Support on the Drum
SD003
drum
front support
Advertising