Routing cables – Dynojet Scooter Dyno SD-12 Installation Guide User Manual
Page 23
Advertising
I N S T A L L A T I O N
Installation
Version 3
Model SD12 Scooter Dynamometer Installation Guide
2-7
R
OUTING
C
ABLES
1
Route the pickup card cable to the Breakout board.
Note: The pickup card is already installed and is located on the drum.
2
Route the 25-pin RS232 computer cable from the Breakout board to the dyno
electronics CPU Module.
3
Route the 9-pin cable from the RS232 port on the dyno electronics to your
computer.
For more information on wiring the Breakout board, refer to “Wiring the
Breakout Board” on page 2-8. For more information on connecting cables to the
dyno electronics, refer to “Dyno Electronics” on page 1-7.
Figure 2-6: Routing Cables
SD032
breakout board
pickup card cable
pickup card
25-pin computer
cable
Advertising