Wiring the breakout board – Dynojet Scooter Dyno SD-12 Installation Guide User Manual
Page 24
Advertising
Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 2
Installation
2-8
W
IRING
THE
B
REAKOUT
B
OARD
1
Attach the pickup card cable to the Breakout board. The pickup card cable has
four wires which connect to the wiring block labeled DRUM 1.
2
Attach the 25-pin RS232 computer cable to the Breakout board.
3
Verify jumpers J1 and J2 are set for the digital brake as shown in Figure 2-7.
Figure 2-7: Wire the Breakout Board
• Red wire connects to R1
• Black wire connects to B1
• White wire connects to W1
• Ground (shield) wire connects to S1
25-pin computer cable
pickup card
J1
J2
digital brake
Advertising