Dynojet Scooter Dyno SD-12 Installation Guide - Manual (Page 28)

Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 2
Fold and Move the Dyno
2-12
O PENING THE D YNO
1 Lift the spring plunger and slide the wheel clamp forward. Release the spring
plunger to lock the wheel clamp in position.
2 Lower the ramp to the floor.
3 Squeeze the control lever to release the front support.
4 Lower the front support to the floor.
Figure 2-11: Opening the Dyno
SD022
slide wheel
clamp forward
control lever
lower ramp