Dynojet Scooter Dyno SD-12 Installation Guide User Manual
Page 22
Advertising
Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 2
Installation
2-6
6
Route the control cable, lever, and control lever bracket from the drum along the
inside of the front support.
Note: The control cable is coiled up and secured to the drum.
7
Secure the control lever bracket to the inside of the front support using two
1/4-20 x 5/8-inch pan-head torx screws.
8
Secure the control cable to the inside of the front support using two cable ties.
Figure 2-5: Install the Control Lever Bracket and Cable
SD023
control lever
control cable
control lever
bracket
cable ties
Advertising