Door installation – EFCO 5XP Series User Manual
Page 14
EFCO CORPORATION 3/21/2013 PART NO. YW43
Page 14 of 34
5XP SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Section V: Door Installation
1. Assemble the door frame and prepare the door frame for installation into the opening. (Page
19 of 34)
2. Once the door frame has been assembled, position the door frame into the opening above
the sill starter. Now interlock the door frame sill with the sill starter. Adjust the door, side to
side, so as to have an equal caulk width at both jambs. Drive in the continuous arrow shim
(WNA3) into cavity between door frame sill and sill starter. Sealant that is required over the
arrow shim will be addressed later in these instructions. Preparations for anchorage of the
jambs are now ready. (See Fig. J)
Fig. J
WNA3 ARROW SHIM