ETS-Lindgren 4340 CCTV Systems - Manual (Page 29)

Wall or Ceiling Mount the Camera | 29
6.0 Wall or Ceiling Mount the Camera
Before installing any components, follow the
safety information in the ETS-Lindgren
Product Information Bulletin included with your
shipment.
Before you mount the camera, complete the installation of the 10/100 Ethernet
filter.
See the 10/100 Ethernet Filter Installation Manual for the
pre-installation requirements and installation instructions for the filter.
They are not included in this document.
Follow these instructions to mount the camera from the wall or ceiling. To mount
the camera on a tripod, see If You Have a Tripod Mount on page 37.
1. Assemble the two 12-inch and one 6-inch pipe lengths as required by
your installation, and connect them with the pipe-to-pipe couplers.
Manually tighten the couplers.
Do not use the elbow joint if mounting the camera from the ceiling.
2. Run the power cable and the Ethernet cable from the camera through
the pipe.