Archived 4/2/10 – ETS-Lindgren HI-4456 Isotropic Electric Field Probe (Archived) User Manual
Page 31
Page — 26
HI
n
4456 Manual
return. If the command does not require the probe to
return any data, the probe simply responds with the
command letter and a carriage return. If an error occurs,
the probe responds with an error code, as detailed in
Appendix A.
Commands
Command
Description
B
Read battery voltage.
Cx
Set baud rate.
x = 1 sets rate to 2400 baud
x = 2 sets rate to 9600 baud
New baud rate does not take effect until the next
power-up.
Dx
Read probe data.
x = 1 enables short form output
x = 2 enables long form output
Lx
Load table data. x = ASCII hex data
Rx
Set range. x = 1, 2, 3, 4 or N (next range)
Sx
Sleep timer. x = number of seconds to wait for
a command before putting probe into the sleep
mode.
Tx
Read Temperature. x = C or F
Ux
Set unit type. x = 1, 2, 3, or N (next unit)
1 = V/m
2 = mW/cm²
3 = [V/m]²
Archived 4/2/10