JDC Electronic SA Geos 11 - Manual (Page 28)

Operation
This type of memory displays all the recordings carried out manually.
To record manually (from any screen, whether instrument turned on or
off), press simultaneously the
and buttons for a short time. The
message indicates that the recording has indeed been
made. Please note that this button combination is also used to launch the
chronometer, hence the
indication.
Each manual recording features the time and date and stores all the
readings of all the sensors (including the combination of sensors) at the
time of the recording.
Viewing
To view manual recordings, go to the special menu and display the
Manual Recordings (
) screen, view the recorded values by pressing
briefly on the button. The indication or on the upper block
lets you know which way the data is viewed (increasing or decreasing
order). To change direction, press briefly the
button when the
indication or is flashing. To view the date and time of each
recording, double-click on the button when you have accessed the
recording in question (when the indication or is flashing).
When viewing recordings, the message is displayed when you get
to the end of the recordings (there is an at the beginning and at the
end of the recordings). If the message appears, this means that
the instrument is currently searching for data. You need to wait until the
indication disappears.
The instrument automatically exits the view mode after 5 seconds or by
pressing the
button for 2 seconds.
The default screen is used to display the memory content. However, you
may view other values, since the instrument stores all the readings of all
the sensors (including the combination of sensors) during each recording.
Example: You view the manual recordings and you realize that the
altitude is displayed on the lower block, when instead of the altitude at
the time of recording, it is the height that you want to know. Exit the
special menu and display the standard screen; select the lower block and
then display the height. Once this operation is completed, go back to the
special menu and display the screen for manual recordings, you will then
see that it is the value of the height (at the time of the recording) which is
displayed and no longer the altitude.
28