JDC Electronic SA Geos 11 - Manual (Page 30)

History
Display
is displayed if the memory is empty (no
recordings).
The default screen is used to display the memory content. In
the example shown opposite, this screen is the standard
screen with the basic measuring modes (wind speed,
humidity, relative pressure and compass heading).
The upper block displays or / which flashes when being
accessed.
Operation
This type of memory displays all the automatic recordings made based
on the selected rate (configurable from 0.5 second to 24 hours). The
data is constantly being recorded, whether the instrument is turned
on or off. Each recording features the time and date and stores all the
readings of all the sensors (including the combination of sensors) at the
time of the recording.
Viewing and rate selection
The process for viewing and selecting the rate is the same as that used
for Measurements based on Selected Rate; please refer to previous
sections.
Other
States of the Instrument
The instrument features several operating states. To find out which
operating state your instrument is currently in (off or on), press 3 buttons
simultaneously and briefly, then release them. For 2 seconds, your
instrument displays: the state, the software version, and the battery level.
When the instrument is turned off, the two possible states are Storage
and OFF, while when it is switched on, the possible states are Stop Auto,
Permanent and Out PC.
30