JDC Electronic SA Geos 11 - Manual (Page 31)

Storage
31
The example shown opposite indicates that the instrument
is in the storage state; the clock and sensors have stopped,
and there is no automatic recording. This is the default
state of the instrument when it comes off the production
line, thus avoiding the depletion of the battery if the
instrument is stored for a long period of time.
Should you wish to set the instrument into the storage state
yourself, please proceed as follows: when the instrument is
turned off, keep the 3 buttons pressed down for at least 4
seconds; when the screen shown opposite is displayed,
release the buttons then keep the MOD (
) button down.
The message means that the ‘storage’
state is activated.
OFF
The instrument is off. Both the screen and sensors are off,
but the clock and automatic recordings are still active.
The instrument switches to the OFF state after being
turned off manually or automatically (please refer to the
Section entitled “Turning the Instrument Off”).
Automatic Stop
The (auto stop) state means that the instrument will
switch off automatically three minutes after one of the
buttons was last pressed (default setting), or when turned
off manually (see Section entitled “Turning the Instrument
Off”).
Whenever it is turned off (whether automatically or
manually), the instrument displays a countdown on the
large block and shows the time left until the auto stop (at
the end of 3 minutes in this case), or the message
if the instrument was set for a state of
permanent operation.
The time elapsed before the automatic stop may be
adjusted (from 20 seconds to 24 hours). Default setting: 3
minutes. To change this time span: turn off the instrument
manually and, when the countdown is displayed, release