JDC Electronic SA Geos 11 - Manual (Page 29)

Measurements Based on Selected Rate
Display
is displayed if the memory is empty (no
recordings).
The default screen is used to display the memory content.
In the example shown opposite, this screen is the standard
screen with the basic measuring modes (wind speed,
temperature, digital and analogue compass heading).
The upper block displays or / which flashes when being
accessed.
Operation
This type of memory displays all the automatic recordings made based
on the selected rate (configurable from 0.5 second to 24 hours). The
data is only recorded when the instrument is switched on. Each
recording features the time and date and stores all the readings of all the
sensors (including the combination of sensors) at the time of the
recording.
Viewing
To view the recordings made automatically, go to the special menu and
display the Measurements based on selected rate (
), then press
briefly the button to view the recorded values. The viewing process is
the same as that followed for ‘Manual Recordings’ (please refer to
previous Section).
Selecting the rate of recordings
Go to the special menu and display the ‘Measurements
Based on Selected Rate’ screen (
), then press the
button for some time. Release the button as soon as you
enter the calibration function (screen opposite). Use the
button to select the direction of the adjustments
(
increment, decrement), and set the rate with the help
of the button. Keep the button down to confirm your setting.
29