Jeep 2009 Wrangler - Owner Manual - Manual (Page 120)

5. Unlatch the header panel latch located at the top of the
windshield.
6. Remove the panel.
To remove the right panel, follow the steps above except
for Step 2.
Front Panel(s) Installation
NOTE: Set the panels on the windshield frame so that
there is no overhang. Also, make sure that the panels are
sitting flush with the body.
1. Install the right panel first, then the left panel.
2. Reinstall the panel(s) using the same steps for removal
in reverse order.
Front Panel(s) Installation Only (With Rear Hard
Top Removed)
1. Turn the left and right panels over and move the
spacer block (located on the rear of the panel) upward 90
degrees.
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE