Kontron CP3003-V uEFI BIOS - Manual (Page 51)

CP3003-SA/CP3003-V uEFI BIOS The uEFI Shell
ID 1053-4014, Rev. 2.0 Page 45
D R A F T — F O R I N T E R N A L U S E O N L Y
USAGE:
(continued)
Command: kboardconfig <option> <parameter>
Set option “Pxe” to parameter “all”:
COMMAND / RESPONSE EXAMPLE:
Shell> kboardconfig Pxe all
The response for “kboardconfig” with <option> and <parameter> is the
display of a status line indicating the performance status of the command
and one or more lines providing further information related to the
command performance.
OPTIONS: The listing below provides an overview of the possible options and a
short description of their functionality.
To view all of the possible parameters for a given option, use the
command “kboardconfig <option>”.
OPTION DESCRIPTION
StorageOprom Used to launch the Storage PCI OPROM
When disabled it includes the onboard RAID option
ROM
PrimaryDisplay Used to select the primary display device
auto: Automatically detect primary display device
igfx: Use internal graphics, if enabled
peg: Try to use video on the PCIe graphics port, if
present (CP3003-SA only)
pci: Try to use video on the PCI(e) bus first
Vga Used to select the VGA port configuration
VgaInterrupt Used to enable the VGA interrupt generation
SataMode Used to select the operational configuration for the
SATA controller
ide: SATA ports operate as two IDE controllers
ahci: SATA ports operate as one 6-port AHCI
controller
raid: SATA ports form a RAID device
Note: For this command to take effect, the system
must be re-booted. During the bootup, it is
possible to select a menu to specify the
desired RAID configuration. Entry to this menu
is achieved by pressing “Ctrl + I” when
requested during the bootup.
kboardconfig (continued)