Kontron KTLX800-pITX - Manual (Page 17)

KTD-S0022-C Page 12 Getting Started
KTLX800/pITX User's Guide
5 Getting Started
Getting started with the KTLX800/pITX is simple. Take the following steps:
ry module into the RAM socket.
Connect a DVI monitor (analog input) to the CRT connector.
Plug a keyboard and/or mouse to the USB connector(s).
❹
o the
KTLX800/pITX power supply connector.
front
Enter the BIOS by pressing the Del key during boot-up. Make all changes in the BIOS Setup.
See the BIOS Setup chapter of this manual for details.
6 em Memory
The KT 00
❶ Plug a suitable DDR-SDRAM memo
❷
❸
Attach a harddisk to the S-ATA connector.
❺ Make sure all your connections have been made correctly. Connect the power supply t
❻ Turn on the board by shortening the power button pins with a push button on the power
panel header (J1506) or use the autostart jumper (J1301).
❼
Syst
LX8 /pITX uses only 200 pin Small Outline Dual Inline Memory Modules (SODIMMs). One soc
+2.5V unbuffered DDR200 up to DDR333 SDRAM of up to 1 GB.
ount of memory available on the SDRAM module is used for main memory and graphi
ket is
available for
The total am
c memory
on the KTLX800/pITX. Shared Memory Architecture (SMA) manages the sharing of the system memory
etween graphic controller and processor. Therefore the full memory size is not available for software
applications.
b
Attention: If you use the ACPI power mode S3 (Suspend to RAM) the DDR-SDRAM speed setting in the Bios Setup must be identical
with the nominal speed of the RAM module or select the 'Auto' setting - otherwise the System Bios crashes during the
resume sequence.
DDR400, DDR433 or DDR466 modules can only be operated with the DDR333 timing.