Kt690 family, Power connector (atxpwr) – Kontron KT690-mITX (BGA) - dual core User Manual

Page 30

Advertising
background image

KT690 Family

KTD-00738-J

Public User Manual

Date 2012-06-01

Page

30

Power Connector (ATXPWR)


The KT690 boards are designed to be supplied from a standard ATX or BTX power supply.

ATX/ BTX Power Connector:

Note

Pull
U/D

Ioh/Iol

Type

Signal

PIN

Signal

Type

Ioh/Iol

Pull
U/D

Note

-

-

PWR

3V3

12 24

GND

PWR

-

-

PWR

+12V

11 23

5V

PWR

PWR

+12V

10 22

5V

PWR

-

-

PWR

SB5V

9

21

5V

PWR

-

-

-

-

I

P_OK

8

20

-5V

PWR

-

-

1

-

-

PWR

GND

7

19

GND

PWR

-

-

-

-

PWR

5V

6

18

GND

PWR

-

-

-

-

PWR

GND

5

17

GND

PWR

-

-

-

-

PWR

5V

4

16 PSON#

OC

-

-

-

-

PWR

GND

3

15

GND

PWR

-

-

-

-

PWR

3V3

2

14

-12V

PWR

-

-

-

-

PWR

3V3

1

13

3V3

PWR

-

-


Note 1: -5V supply is not used onboard.
Note 2: Use of BTX supply not required for operation, but may be required to drive high-power PCI Express
x16 Add cards.


ATX+12V Power Connector:

Note

Pull
U/D

Ioh/Iol

Type

Signal

PIN

Signal

Type

Ioh/Iol

Pull
U/D

Note

1

-

-

PWR

GND

1

3

+12V

PWR

-

-

1

1

PWR

GND

2

4

+12V

PWR

1


Note 1: Use of the 4-pin ATX+12V Power Connector is required for operation of the KT690 boards.

See chapter “Power Consumption” regarding input tolerances on 3.3V, 5V, SB5V, +12 and -12V (also refer
to ATX specification version 2.2).

Control signal description:

Signal

Description

P_OK

P_OK is a power good signal and should be asserted high by the power supply to indicate
that the +5VDC and +3.3VDC outputs are above the undervoltage thresholds of the power
supply. When this signal is asserted high, there should be sufficient energy stored by the
converter to guarantee continuous power operation within specification. Conversely, when the
output voltages fall below the undervoltage threshold, or when mains power has been
removed for a time sufficiently long so that power supply operation is no longer guaranteed,
P_OK should be de-asserted to a low state. The recommended electrical and timing
characteristics of the P_OK (PWR_OK) signal are provided in the ATX12V Power
SupplyDesign Guide
.
It is strongly recommended to use an ATX or BTX supply with the KT690 boards, in order to
implement the supervision of the 5V and 3V3 supplies. These supplies are not supervised
onboard the KT690 boards.

PS_ON#

Active low open drain signal from the board to the power supply to turn on the power supply
outputs. Signal must be pulled high by the power supply.

Advertising
This manual is related to the following products: