Kontron AM4022 IPMI Firmware - Manual (Page 23)

AM4022 IPMI Firmware
ID 1052-3624, Rev. 1.0 Page 23
3.2 Set Control State (Firmware Hub, Boot Order)
Table 6: Set Control State
COMMAND LUN NetFn CMD
Set Control State (Firmware Hub, Boot Order) 00h OEM = 3Eh 20h
REQUEST DATA
Byte Data Field
1 Control ID:
00h = Firmware hub (SPI boot flash) Selection
9Dh = Boot Order Configuration
2 Control State for SPI boot flash selection:
(These settings are stored in EEPROM and applied (to logic) each time the IPMI controller
detects power-on)
00h = Standard SPI boot flash is selected (default)
01h = Recovery SPI boot flash is selected
Please note that this selection may be forcibly overridden either by the DIP Switch SW3,
switch 2 (refer to the AM4022 User Guide, Table 4-3).
To be able to change the SPI boot flash selection via the Set Control State command, the
recovery SPI boot flash must not be previously selected.
In case of a failed boot process from the standard SPI boot flash, the IPMI controller will
select the recovery SPI boot flash and boot the board again.
In case of a boot failure from the recovery SPI boot flash, the board locks up.
Refer to Chapter 8, uEFI BIOS Failover Control - Automatic SPI Boot Flash Selection, for
further information.
Control State for Boot Order Configuration:
(These settings are stored in EEPROM and applied (to logic) each time the IPMI controller
detects power-on)
00h = No override, boot as usual
01h = Next boot device is: Floppy
02h = Next boot device is: HDD
03h = Next boot device is: CD
04h = Next boot device is: Network
05h = Next boot device is: USB Floppy
06h = Next boot device is: USB HDD
07h = Next boot device is: USB CDROM
RESPONSE DATA
Byte Data Field
1 Completion Code