Kontron AM4022 IPMI Firmware - Manual (Page 47)

AM4022 IPMI Firmware
ID 1052-3624, Rev. 1.0 Page 47
The following table describes the functions of the IPMI Module Management LEDs.
Table 15: Module Management LED Functions
LED COLOR STATE NORMAL MODE
OVERRIDE MODE
selectable by user or
carrier, depending
on PICMG LED
command
LED1
(Out-of-
Service
LED)
red off Default By user:
• Only lamp test
on MMC out of service or in reset
state
blinking MMC firmware upgrade
LED2
(Health
LED) green/amber/red off Payload is off; module is not pow-
ered By user:
• Only lamp test
green Module is healthy (normal opera-
tion) and all related sensors are
within the specified range
amber Payload is on and at least one
sensor is out of range
red Reserved
HS LED
(Hot
Swap
LED) blue on a) Module ready for hot swap
extraction, or
b) Module has just been inserted
in a powered system By carrier:
• On
• Off
• Slow/Fast Blink-
ing
By user:
• Only lamp test
blinking Module hot swap in progress;
module not ready for extraction
off Module is in normal operation