7 power up the board, Power up the board, J1 – cf master – Kontron MSM800BEV User Manual
Page 24
Advertising
MSM800BEV
/ Quick Start Guide
www.kontron.com
22
4.7 Power Up the Board
1. Check that the voltage is regulated to +5Volt and that the polarity is correct.
Attention!
The supply voltage must be in the range of 4.9Volt to maximum 5.25Volt.
2. Switch on the connected monitor.
3. Switch on the external 5V power supply.
Attention!
Jumper J1 determines the mode of the CompactFlash disk.
J1 – CF Master
Advertising