Kontron MSM800BEV - Manual (Page 31)

MSM800BEV / Connectors & Jumpers
www.kontron.com 29
5.1.3 X1 Power Supply
Pin Signal Pin Signal
1 GND 2 VCCSUS +5Volt Input Supply
3 NC 4 (+12V input)
5 NC 6 Main_SW (Push button to switch on the board if J2 is open)
7 GND 8 VCCSUS +5Volt Input Supply
VCCSUS = 5Volt Main Supply Input
Pin placement:
5.1.4 X10 VGA Monitor (CRT-signals)
X10 Header 15 pins HiDensity DSUB
10 Pin -M Signal Pin Signal
2 VGA red 1 Red
4 VGA green 2 Green
6 VGA blue 3 Blue
8 Horizontal Synch 13 H-Synch
9 Vertical Synch 14 V-Synch
5 + 11 Bridged
1 Ground 5, 6, 7, 8 Ground
3 NC
5 NC
7 Serial_Data 12 DDC-SDA
10 Serial_Clock 15 DDC-SCL
The VGA-CRT signals from X10 must be wired to a standard VGA HiDensity DSub connector (female):
The LCD signals must be wired panel specific.
Solder-side view of the female 15pin HiDSub
1 3 5 7
2 4 6 8