Sdcard slot, X110 - rs232, Fig. 13: sdcard slot – Kontron KBox C-101 User Manual
Page 23: Fig. 14: sd card (not included)
7. System Overview
KBox C-101 – User’s Guide (Version 2.00)
7.3.6. SDCARD Slot
This slot, marked “SDCARD” is an SDHC/SDXC compliant interface realized using a standard SD card connector. It is
accessible at the front side of the KBox C-101 (Fig. 10) and is located between the serial interface (RS232/X110) and
DISPLAYPORT.
•
This SD card reader supports SD, SDHC and SDXC cards.
•
SD card activity is indicated by the SD LED on the KBox C-101 front side.
•
This interface permits hot-plugging of SD card. The system can also be booted from this interface.
Fig. 13: SDCARD slot
Fig. 14: SD card (not included)
This interfaces support hot-swapping.
To prevent data loss when removing the SD or SDHC or SDXC card, it may not be removed during a read
or write access [while the green SD LED (Fig. 16) of the drives is green flashing].
To install a card please perform following steps:
1. Insert the SD/SDHC/SDXC card into the SDCARD slot marked “SDCARD” (see Fig. 10. and Fig. 13) on the front side of
the KBox C-101.
2. Gently push the card into the open slot until it snaps (clicks) into place. When the card was inserted correctly, the
green SD LED (Fig. 16) of the multi card reader lights up (provided that the computer is switched on and booted up).
Do not act with force when inserting the memory card. If this seems to be necessary, the card is not
inserted properly in the guide of the slot. Remove the card from the slot and re-insert it with care.
3. The card is ready for use.
To remove a card, proceed as follow described:
1. Push the SD/SDHC/SDXC card in all the way and then let it “push” itself out (there is a spring loaded mechanism in the
holder which does this).
2. Once the card is released, grasp the protruding part of the card and remove the card from the holder.
7.3.7. X110 - RS232
This interface (X110, Fig. 10) is provided as a 9-pin D-SUB connector; it is RS232 configured and allows the connection of
a serial peripheral. For pin assignment refer to subsection 18.1.2.
www.kontron.com
21