Mercedes-Benz CLS-Class 2011 Owners Manual - Manual (Page 285)

Removing cover in rear bumper
G Warning!
In order to avoid possible serious burns or
injury, use extreme caution when removing
the rear cover, because the rear exhaust pipe
is extremely hot.
X Press on cover : as indicated by the
arrow.
X Fold cover : down to reveal the threaded
hole for the towing eye bolt.
Fixing towing eye bolt
Example illustration front bumper
X Take the towing eye bolt and, if so
equipped, the wheel wrench from the
vehicle tool kit (
Y page 224).
X Screw towing eye bolt ; clockwise into
threaded hole to its stop.
X Insert wheel wrench into towing eye and
tighten towing eye bolt ; by turning it
clockwise.
or
X If your vehicle is not equipped with a wheel
wrench, use a suitable object to turn the
towing eye bolt.
Removing towing eye bolt
X Loosen towing eye bolt ; by turning it
counterclockwise.
X Unscrew towing eye bolt ;.
X Reinstalling cover: Fit cover :
(
Y page 282) and snap it into place.
X Store the towing eye bolt ; and wheel
wrench back into the vehicle tool kit.
Towing with front axle raised
! The vehicle may be towed only for
distances up to 30 miles (50 km) and at a
speed not to exceed 30 mph (50 km/h).
X Make sure the ignition is switched on.
X With the vehicle at a standstill, depress the
brake pedal and keep it pressed.
X Shift the automatic transmission into
neutral position
N.
X Release the brake pedal.
X If engaged, release the parking brake.
X Switch off the automatic central locking
(
Y page 123).
X Switch off the ignition and leave the
SmartKey in the starter switch.
X Switch on the hazard warning flasher
(
Y page 90).
! Because the ESP ® operates
automatically, the engine and ignition must
be shut off (SmartKey in starter switch
position
0 or 1 or KEYLESS-GO start/stop
button in position 0 or 1) when the vehicle
is being towed with the front axle raised.
Towing the vehicle
283
Practical hints
219_AKB; 4; 54, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-11T16:21:02+02:00 - Seite 283
Z